Machifit M542C Stepper Motor Deiver Controller for 2 Phase Stepper Driver

Description
M542C Stepper Motor Deiver Controller for 2 Phase Stepper Driver M542C 20-50 VAC 1.0-4.2A
Specifications
Parameters
M542C
Min
Typical
Max
Unit
Output Current
1.0
/
4.2(3.0 RMS)
A
Supply Voltage
20VAC
36VAC
50VAC
V
Logic Signal Current
7
10
16
mA
Pulse Input Frequency
0
/
300
KHz
Step Revolution
400
25600
Pulse/Rev
Isolation Resistance
500
MΩ
Suitable Stepper Motors
NEMA 16, 17,23
P1 Function
M542C Details
PUL+
Pulse signal:In single pulse (pulse/direction) mode, this input represents pulse signal,
each rising or falling edge active (set by inside jumper J1); 4-5V when PUL-HIGH, 0-0.5V
when PUL-LOW. In double pulse mode (pulse/pulse) , this input represents clockwise (CW)
pulse,active at high level or low level (set by inside jumper J1, J2). For reliable
response, pulse width should be longer than 1.5μs.
Series connect resistors for current-limiting when +12V or +24V used. The same as DIR and ENA signals.
PUL-
DIR+
DIR signal:In single-pulse mode, this signal has low/high voltage levels, representing two directions of motor rotation; in double-pulse mode (set by inside jumper J3), this signal is counter-clock (CCW) pulse,active at high level or low level (set by inside jumper J1, J2).
For reliable motion response, DIR signal should be ahead of PUL signal by 5μs at least.
4-5V when DIR-HIGH, 0-0.5V when DIR-LOW. Please note that rotation direction is also
related to motor-drive wiring match. Exchanging the connection of two wires for a coil to
the drive will reverse motion direction.
DIR-
ENA+
Enable signal:This signal is used for enabling/disabling the drive.
High level (NPN control signal, PNP and Differential control signals
are on the contrary, namely Low level for enabling.) for enabling
the drive and low level for disabling the drive. Usually left UNCONNECTED (ENABLED).
ENA-
P2 Function
M542C Details
+Vdc
Power supply, 20~50 VDC, Including voltage fluctuation and EMF voltage.
GND
Power Ground.
A+, A-
Motor Phase A
B+, B-
Motor Phase B
Features
– Extra-low motor noise offers excellent quietness.
– Anti-Resonance, provides optimum torque and nulls mid-range instability.
– Self-test and Auto-configuration technology, offers optimum responses with different motors.
– Microstep resolutions programmable.
– Output current programmable, from 1.0A to 4.2A.
– Pulse input frequency up to 300 KHz.
– Automatic idle-current reduction.
– Supports PUL/DIR and CW/CCW modes.
Package Included
1 Pc *:M542C Stepper Motor