N2061SA Shortwave Antenna Analyzer Frequency Range 1.1MHz~1300MHz Resistance/Impedance/VSWR/s11

English version N2061SA Short Wave Antenna Analyzer Frequency range 1.1MHz~1300MHz resistance/impedance/SWR/s11 factorysale
model:N2061SA
S11 Working frequency:1.11MHz~1300MHz
S21 Working frequency:1.11MHz~600MHz
The frequency step by step:1kHz
display:2.4 inch TFT Resolving power 320*240(QVGA)
Battery capacity:2000mAH(7.4Wh)
Power consumption
Charging current:400mA
Charger port:USB(only act as charge port)
Automatic shut-down:Can be set(it has been open for 5minutes~60minutes optional)
Measurement parameters:resistance,reactance,standing,s11,s21
resolution:Four significant figures
Frequency accuracy
connector:SMA-K
Measurement range:impedance:1Ω~1000Ω(The absolute value of the impedance)
:standing:1.000~65
:s11(dB):0dB~-50dB
:s21(dB):6dB~-60dB
error:s21(dB):+/-3Db(6dB~-60dB)
Error (s11 single-point measurement):impedance
(Z
(Z
:standing
:s11:0.1 dB /5° (0dB~-10dB)
:(dB/°):1 dB /10° (-10dB~-20dB)
::5dB/20° (-20dB~-40dB)
Error(S21):S21:±2dB
S11 directivity
Sweep Points:280
Output level:-18dBm
working temperature:5℃~40℃
atmospheric pressure:860hPa~1060hPa
Cable length measurement
Characteristic impedance measurement of transmission line
Descriptions
This instrument has four interfaces:single point measurement, scanning, system information, correction and calibration
The default boot into single-point measurement interface.
Note:For the convenience of the user, each time calibration correction options will automatically change to the user calibration. Meanwhile, in order to ensure the integrity of the calibration, the calibration process, the automatic shutdown function fails, the consistent boot.
Startup and shutdown
Hold down the CTRL key off press the power switch button.
The boot state, long press (2S above) the switch button, after the release, the instrument will shut down
The boot state, long press (2S above) the switch button, after the release, the instrument will shut down
Recommend the use
1, in order to ensure the accuracy of measurement and calibration, preheat the instrument at least 15 minutes.
2, try to use good quality RF cable and connectors.
3, calibrated cable marked to the next may not need to calibrate and direct use.
4, test cable process affect the measurement accuracy, it is recommended that, where possible, do not choose too long test cable.
5, measurement and calibration before, make sure you are not in a strong wireless signal, so as to avoid interference caused by inaccurate measurements.
6, if the impedance measurements themselves do not understand, you can refer to a vector network analyzer instructions and tutorials. This instrument is equivalent to a single-port vector network analysis.
Package Includes
1x N2061 HF Vector Antenna Analyzer
1x User Manual
1x USB charger cable
1x USB AC adapter