Kafuter K-5202 80g High Temperature Resistant thermal Grease Heat Sink Paste for LED Light CPU PCB COB Chips Special Glue

Features
White thixotropic elastomer
One-part,room cure
Good cold and hot tolerance
Thermal conductivity 1.2
K-5202 is a reinforced thermally conductive silicone elastomer with great adhesion, insulation and dissipation
One part, room cure, packing in soft metal tube
Excellent in cold and high alternating resistance (-60~ 280℃)
No peeling and good disassemble after long time usage
The elastomer with high bonding strength , the shear strength is 30kg/cm3
Specification
Property Name:K-5202
Appearance:White
Viscosity (cp):Thixotropic elastomer
Density(g/cm3):2.0~3.0
Initial Curing Time(25c, min)
Cured Mechanical Properties Tensile Strength (Mpa):>=2.5
Elongation At Break (%):>=100
Shear Strength (Mpa):>=1.5
Hardness(shore A):50~65
Working Temp ( c):-60~280
Electrical Properties Dielectric Strength(kv/mm):>=18
Permittivity (@60Hz):2.8
Volume Resistivity (.cm):1*1015
Coefficient of Thermal Conductivity(w/m.k):1.6
Application
Fill, bond, and seal in electronics
The gap between CPU and radiators
The gap between thyristor control modules and radiator
The filling of high-power electronics modules and radiators etc.
Purpose
The main application is to replace thermal conductive silicone (cream) for CPU and radiator, thyristor module and intelligent control radiator, high-power electric filling adhesive between the module and the radiator. After using this glue, can get rid of the traditional CARDS and screw connection way, the result is more reliable to fill the cooling, simpler process and more economic cost.
How to Use:Clean the un-bonded or uncoated surfaces by removing the rust, ash, and oil, etc.
Application:Pierce the opening with the tip of the cap. Fix the nozzle, and coat the clean surface evenly with the adhesives, then bond the two surfaces.
Curing Condition
The curing progress is from outer surface into inner surface.
The elastomer get cure with the depth of 2~4mm in 24 hours (at room temperature, 55% moisture). if the bonded parts is too deep (especially the parts not easy to contact with air) or the temperature is too low, the full curing time will be extend.
Advise user preparing enough time to let elastomer get full cure in order to keep the properties stably.
Packing Included
1 x Kafuter K-5202 80g Thermal Grease