6mm-13mm Staplers Air Stapler Gun Air Nailer Air Tool

Specification
Dimension:45X145X210 mm
Weight:2.86kg
Power Source:Pneumatic
Required pressure:70-110PSI(4.8-7.5bar)
Max.Pressure:120PSI (8.3bar)
Capacity:100000
Feature
Upholstery Stapler.
Uses:1/4inch to 1/2inch 20-gauge staple;
Comfortable rubber soft grip;
Accepts 1013J Series Staples.
Air Nailer Trouble Shooting
Symptom:Problem:Solutions
Air nailer’s leak near top of tool or in trigger area:1.O-ring in trigger valve are damage
2. Air nailer’s trigger valve head are damage
3.Air nailer’s trigger valve stem, seal or O-ring are damaged:1.Check and replace O-ring
2.Check and replace
3.Check and replace trigger valve stem, seal or O-ring
Air Nailer’s leak near bottom of tool:1.Loose screws
2.Worn or damaged O-ring or bumper:1.Tighten screws
2.Check and replace O-ring bumper
Air leak between body and cylinder cap:1.Loose screws
2.Worn or damaged O-ring or bumper:1.Replace bumper
2.Adjust the air pressure
Blade driving fastener too deep:1.Worn bumper
2.Air nailer pressure is too high:1.Verify adequate air supply
2.Place 2 or 6 drops of oil into inlet
3.Check and replace O-ring or seal
4.Replace damaged air nailer internl parts
Air nailer does not operate well:can not drive fastener or operate slugishly:1.Inadequate air supply
2.Inadequate lubrication
3.Worn or damaged air nailer’s O-ring or seals
4.Exhaust port in cylinder head is blocked:1.Verify adequate air supply
2.Place 2 or 6 drops of oil into air nailer’s inlet
3.Check and replace O-ring or seal
4.Replace damaged internl parts
Tool skips fasteners:1.Worn bumper or damaged spring
2.Dirt in front plate of the air nailer
3.Dirt or damage prevent fasteners from moveing freely in spray gun’s magazine
4.Worn or dry air nailer’s O-ring on piston or lack of lubrication
5.Cylinder cover air nailer’s seal leaking:1.Repalce bumper or pusher spring
2.Clean drive channel on front plate
3.Air nailer’s magazine needs to be cleaned
4.O-ring need to be replaced and lubricate
5.Replace sealing washer
Tool jams:1.Incorrect or damaged fasteners
2.Damaged or worm driver guide
3.Air nailer’s magazine or nose screw loose
4.Air nailer’s magazine is dirty:1.Change and use correct fastener
2.Check and replace the driver
3.Tighten the magazine
4.Clean the magazine
Package included
1XAir Staple Gun